2026 Kona Remote X

Archived: Frame: Kona 6061 Aluminum Butted 180mm Travel · Fork: Fox 38 Performance Elite 180mm travel

• Look for dents or shape changes and inspect the edges of welds around the head tube, bottom bracket, seat cluster and suspension mounts for hairline cracks.

Archived: Fork: Fox 38 Performance Elite 180mm travel · Rear shock: Fox Float X Performance Elite 230x62.5mm

• Inspect the fork stanchions for scratches or coating wear, look for oil or dirt rings at the seals, and cycle the fork through its travel while checking for binding or bushing play.
• Inspect the shock shaft and seals, cycle the rear suspension through its travel and check for oil, air loss, binding or unusual top-out and bottom-out noises.
• Hold the rear brake and load the suspension from several directions. Check pivots, bearings and mounting hardware for knock, looseness or side play.
• Ask for dated fork, shock and pivot-service records. A clean exterior does not establish the condition of internal seals, oil, bushings or bearings.

Archived: Rear derailleur: SRAM Eagle 90 Transmission · Crankset: FSA CK-745 155mm 34t · Cassette: SRAM Eagle 70 10-52t 12spd · Chain: SRAM Eagle 70 T-Type

• Shift through every available gear under light load. Hesitation, skipping or inconsistent indexing can reflect wear, damage, poor adjustment or mismatched replacement parts.
• Measure chain wear with a compatible gauge and inspect chainring, cassette or freewheel teeth. A new chain does not rule out wear in the remaining drivetrain.
• Turn the cranks slowly, feel for rough bearings and check for side-to-side play. Inspect crank arms, chainring bolts and pedal threads for looseness or damage.

Archived: Brakes: Brake Calipers: TRP EVO PRO; Front Brake Rotor: TRP 220mm 6B 2.3mm; Rear Brake Rotor: TRP 203mm 6B 2.3mm; Brake Levers: TRP EVO PRO

• Inspect pads and braking surfaces, check the complete cable or hose path, and confirm both controls feel consistent and return cleanly.

Archived: Wheel size: 29" · Rims: WTB HTZ Trail i30 · Hubs: (F) Formula 15x110mm / (R) Formula 12x148mm HG · Front tire: Maxxis Assegai 29x2.5" DoubleDown MaxxGrip · Rear tire: Maxxis DHR II 27.5x2.4" DoubleDown MaxxTerra

• Spin both wheels and watch for side-to-side and vertical movement. Check spoke tension, rim condition and hub play.
• Inspect both tire casings for cuts, cracking, plugs, bulges or exposed threads and confirm the installed sizes are safe for the rims and available frame and fork clearance. This record indicates different front and rear wheel diameters, so verify each tire at its correct end.

Archived: Headset: FSA NO.55R/57 ZS56/ZS56 · Handlebar: Kona 35mm / Back 10º / Up 5º / Rise 38mm / Width S 760mm / M 780mm / L-XL 800mm · Stem: Kona 35mm / Rise 0º / Length 40mm · Seatpost: TranzX Dropper +RAD Internal 31.6mm / Length S 150mm / M 170mm / L 200mm / XL 230mm · Saddle: WTB Volt Cromoly SL

• Apply the front brake and rock the bike to check for headset play or notchiness. Inspect the stem, handlebar and clamp zones, then confirm every fastener and control is secure.
• Cycle the dropper post repeatedly. It should reach full travel, remain extended under load and have no unusual oil, excessive rotational play or damaged remote, cable, hose or battery.

Archived: Kona Remote X · electric-assist identification

• Inspect the battery case, mount, lock and electrical contacts for cracks, impact, corrosion, swelling, overheating marks or looseness. Confirm the battery charges normally.
• Confirm the correct charger, battery keys and removable system parts are included. Check charger cables and connectors for damage or improvised repairs.
• Power the system on from cold, check the display for warnings, and test every assist mode. Assistance should engage and stop predictably without intermittent cutouts or abnormal motor noise.
• Ask for available battery-health, cycle-count, diagnostic and firmware records. Confirm that replacement batteries and system support remain available before agreeing on value.